Universal Sway-Bar Kit $375.00
Discription- 1 1/8" Hollow Bar 4340 Chromoly .750 or 1.00
Bar length 26", 27", 29", or 30"
Billet Aluminum or Steel Swag Rods any length
Billet Aluminum Sway-Bar Arms
Arm Lengths 12", 14", 17", or 19"
1/2" x 1/2" XM 4130 (HT) Chromoly Teflon Coated Hemis
other sizes upon request
Polyurthane Bushings with grease zirks

nice, good price too. any chance of making one a little wider possibly?

That is all the wider that we can get, sorry what size do you need?

probably about 36" its for the rear of a toyota tacoma

Sorry about that

5/8" x 5/8" 4130 Chromoly Heims also available for the same kit

btt

hello

Ben, shoot me a PM or Email about 2 ea for my XRRA buggy build I didnt know you were selling these man right on !!

hardlinecustom@yahoo.com

PM Sent Thanks Paul

What's up!

I could use a full kit but I need 37.5 or wider as well. If you had wider I would be all over it.

Im a little confused on the dimensions. What is the OD of the splines? OD of the the long neckdown section? and the Dia of the bore?
Are the bars heat treated?

Thank you, im sure this information will help others as well.

Ian-

X2 on the wider bars.

is a special order wider bar available? I need one.

Discription- 1 1/8" Hollow Bar 4340 Chromoly .750 or 1.00


??? :confused:

Are they 1 1/8" od working diameter or .75" or 1"? What is hollow and what's the id??

Have you actually calculated the stiffness of this setup?? For a normally mounted sway bar in your lengths only the last few holes on a 30" long .75" od bar seem to be in the "rockcrawling" range. Are these build for racing rigs or what? If they're 1 1/8" or 1" od they're retarded stiff.

I do like the stuff, but I'm just curious as to the specifics of the parts and their intended uses.

I asked for the dimensions above because of the same reasons Benny brings up.
Im guessing that 30" is the longest piece that will fit in his machine. Just a guess.

Yo 5x a reply would be great, im looking to order a sway bar in the next 3 weeks and am interested in your product.

Thanks

Ian

I hope that this pic is what you guys are wanting. And no on the longer bar that is all I can get and yes they are (HT), I will let you know tomorrow on the ID let me know if you have more QUESTIONS.

bttt

Ben-
Anyway to get the arms built to be doglegged out so you could accommodate a wider application if the bars are limited to 30"s?

you might sell more if it wasn't so damn expensivr!

I do have some bars that are bent out. I will try to get some pics today