Wicked_S10
09-23-2007, 04:51 PM
Small Block Ford ZF5 & BW1356 & misc.
Price:$800 OBO. & various
.
.
Description:
I have a small Block Ford ZF 5 speed for sale, out of a 94 F350. Currently behind a 351W in said truck. Shifts fine, and is in good shape. Transfercase is manual shift, Slip Yoke version, and has a leaky rear seal. Trans comes with internal slave cylinder, clutch and pressure plate. I am sorry, but I need the flywheel and the clutch pedal/master cylinder. I will have the trans pulled by the middle of the first week of October.
I also have a decent tail gate from the same truck. It is primer gray, but it is pretty straight yet. $100 OBO.
LB bed liner, free.
LB bed, $100 if you get it before the truck goes to scrap. The passanger side of the bed is straight, a bit of rust in the wheel wells. Drivers side is beat up a bit with rust in the wheel well. Other than that, the bed appears to be in good shape.
I have a EFI 351W out of an '88 bronco, it will be a while before I get it pulled unless someone wants to buy it with the trans. I have never started it, but it turns over freely, and was told it ran when I purchased the bronco. Comes with engine, underhood harness, and ECM. $300 OBO.
I have a BB T-18/NP208, will sell it for $300 OBO.
I have a SB t-18/NP208, hydro bell housing, $400 OBO.
I have a carbed 302 w/ edelbrock 4 barrel, and SB C6, ran fine when pulled, $500 OBO.
I also have a SBC 305, no intake or carb. It has sat in my shop for a few years. I ran it in my Jeep w/ tuned port injection for a couple of seasons. Runs fine, but it will need cleaned up before it is put back together. $100 OBO.
Don't hesitate to make me an offer via PM. I prefer not to ship, but will send stuff FedEx freight on your dime + palatization fee.
Thanks,
Jason
Location (City):Midland
ZIP CODE (for shipping calculations):48640
Will you Ship? (Y/N):Y
Method of shipment (UPS, FedEx, etc): FedEx Freight
Payment method (PayPal, check, MO, etc): Any
Price:$800 OBO. & various
.
.
Description:
I have a small Block Ford ZF 5 speed for sale, out of a 94 F350. Currently behind a 351W in said truck. Shifts fine, and is in good shape. Transfercase is manual shift, Slip Yoke version, and has a leaky rear seal. Trans comes with internal slave cylinder, clutch and pressure plate. I am sorry, but I need the flywheel and the clutch pedal/master cylinder. I will have the trans pulled by the middle of the first week of October.
I also have a decent tail gate from the same truck. It is primer gray, but it is pretty straight yet. $100 OBO.
LB bed liner, free.
LB bed, $100 if you get it before the truck goes to scrap. The passanger side of the bed is straight, a bit of rust in the wheel wells. Drivers side is beat up a bit with rust in the wheel well. Other than that, the bed appears to be in good shape.
I have a EFI 351W out of an '88 bronco, it will be a while before I get it pulled unless someone wants to buy it with the trans. I have never started it, but it turns over freely, and was told it ran when I purchased the bronco. Comes with engine, underhood harness, and ECM. $300 OBO.
I have a BB T-18/NP208, will sell it for $300 OBO.
I have a SB t-18/NP208, hydro bell housing, $400 OBO.
I have a carbed 302 w/ edelbrock 4 barrel, and SB C6, ran fine when pulled, $500 OBO.
I also have a SBC 305, no intake or carb. It has sat in my shop for a few years. I ran it in my Jeep w/ tuned port injection for a couple of seasons. Runs fine, but it will need cleaned up before it is put back together. $100 OBO.
Don't hesitate to make me an offer via PM. I prefer not to ship, but will send stuff FedEx freight on your dime + palatization fee.
Thanks,
Jason
Location (City):Midland
ZIP CODE (for shipping calculations):48640
Will you Ship? (Y/N):Y
Method of shipment (UPS, FedEx, etc): FedEx Freight
Payment method (PayPal, check, MO, etc): Any