Well, i found a good deal on some 9 inches for a YJ. The 9 inch up front is driver side drop. I swapping into a CJ-7 currently with no rear and and 30(pass drop) up front. The 30 and no rear is currently being run by a 4.2/T18/Dana300. Would flipping the dana 300 make these axles work? Except for new driveshafts and cutting some perches, would this be the only things needed to make it work? thanks :smokin:

anyone know? :smokin:

pretty much and reroute the exauhst under the tranny or under the oil pan like on a tj. get some cable shifters for the 300. and you should be fine

thanks, i think my exhaust is already under the tranny! Thanks :smokin: Anyone else?

Should work...

Spring width on the YJ is wider, so you'll have to outboard the springs on the 7 or put new perches on the axle housings

thanks for the reply. i fiqured that out when i got the rear axle! :(

well then i guess you dont need any help