|
ChiScouter 06-18-2002, 10:13 AM The fiberglass bod was on my Scout when I bought it, and the guy who did the conversion was a bit of a butcher. The supports were cut up during the conversion, and are about rusted beyond redemption. Does anyone have a pic of unbutchered fender supports they could post, and does anyone have a relativly rust free pair they are looking to unload? tsm1mt 06-18-2002, 10:22 AM Originally posted by ChiScouter The fiberglass bod was on my Scout when I bought it, and the guy who did the conversion was a bit of a butcher. The supports were cut up during the conversion, and are about rusted beyond redemption. Does anyone have a pic of unbutchered fender supports they could post, and does anyone have a relativly rust free pair they are looking to unload? Jeff, What are "fender supports"? Do you mean front inner fenders? Or the rear wheel arch? Or something else? See the "Fender Hacking" or "fitting 36s" post for pics of how mine all looked when I tore it apart just before I cut 3" out of the arch. :D ChiScouter 06-18-2002, 11:56 AM Tom its Helmer, do you have a link to get to the photo? Maybe radiator support would have been a better term. It is the bulkhead on either side of the radiator that ties the fenders to the radiator, and to the frame tsm1mt 06-18-2002, 12:21 PM Originally posted by ChiScouter Tom its Helmer, do you have a link to get to the photo? Maybe radiator support would have been a better term. It is the bulkhead on either side of the radiator that ties the fenders to the radiator, and to the frame Oops, I figured 'glass SSII From Chicago, you must be Jeff Bade! Rad support.. ahh. You may find a few here - Full write-up on the fender trim (http://www.tmcom.com/~tsm1/scout/faq/fender_trim_for_36.htm) Here's another pic http://tigger.tmcom.com/~tsm1/scout/jpg/racer/moving/image2.jpg harkinoff 06-18-2002, 05:33 PM Sorry man, I just threw a complete set away, but they were for a right hand steer REDDMANIAC 06-18-2002, 09:28 PM Ill have to look for them in my collection of parts, just PM me. Im looking at unloading a whole bunch of shit soon as Im needing to finish my axle swap soon, may even have to unload the KAYLINE. If only I had started AFTER I had the money:( | |