that's right. trying to figure out if i should sell these and what is a fair price.
chevy one ton axles:
dana 60 front, detroit soft locker, 14 bolt full floater rear, detroit locker, 4.56 gears in both, disc brakes all the way around. moser axles in both. narrowed to be 2.5 inches wider than stock cruiser axles. were in 70 fj40, will fit any 40, 45 and 55.
spring perches on top (soa obviously) set up to bolt right into a cruiser. center rear diff.
any ideas?!
don't tell me $50 <IMG SRC="smilies/wink.gif" border="0"> !
read the rules <IMG SRC="smilies/thefinger.gif" border="0"> .
<IMG SRC="smilies/biggrin.gif" border="0"> <IMG SRC="smilies/bounce2.gif" border="0"> <IMG SRC="smilies/bounce2.gif" border="0"> <IMG SRC="smilies/bounce2.gif" border="0">

$51.00 <IMG SRC="smilies/biggrin.gif" border="0">
I would have to have to say at least $2000! Those sure would fit nicely in my fodee! <IMG SRC="smilies/skull.gif" border="0">

heck already narrowed, disc's, lockers, 4.56's...i'd ask $3000-$3500 at least. somebody will buy them. just look at the price of a custom built dana60 front.

Georg

Just call any of the axle manufacturers and ask them how much to narrow an axle and make it 6 lug. That is where all the money is, in the hubs making them 6 lug.

If they are just narrowed and still have 8 lug outers, then the price will go down considerably.

You probably need to get a WF to WF measurement and post how many lugs and you won't have ANY problem selling that setup!

they are 8 luggers.
you know what draws me to this site nightly like a moth to the open flame?
coments like "$51".
all i gotta say to some of the sour-pusses out there is get a sense of humor or get gawn!!!!
<IMG SRC="smilies/bounce2.gif" border="0"> <IMG SRC="smilies/bounce2.gif" border="0"> <IMG SRC="smilies/bounce2.gif" border="0">

Get the WF to WF measurment because that is one thing everyone will want to know.

HEY been a while since I have seen a fj45 waggy, used to have two on them at one time cool rides.....