I have a set of hubs off a RC44, 5 on 5-1/2 pattern, they were in a drum application, I want to use them for discs.

Are they the same as the disc hubs?? I don't have disc version to compare to, and the back face of these hubs ARE machined (as if they would work for a disc).

Does any one know, or can anyone measure a disc hub so I can compare it? Also, anyone have a part # for the studs, or will Chevy studs work? (got a bunch of those)

Thanks.


Also, how do you tell the "large bearing" Chevy spindles from the "small bearing". I thought the "large bearing" were only really used in 3/4T and up applications, but a Search (yes, i searched) resulted in some mixed/confusing information.


thanks
-mark

what measures U lookin for??
I got a hub from a '79 Bronco (disk)
The disk mounts on the backside of hub.
4 3/8" from back of hub (disk mount surf.) to front (where hub lock goes.
2" from back of hub (disk mount surf.) to the back side of hub
1 1/16" from backside of hub to seat for the bearing race(inner).
3 5/8" from nose of hub to the outer bearing race seat.
That what yur lookin for?