ok ive search for hours any havent found what im really looking for and you guys can probally answer my ?'s in 2 minutes. I want to know if the 6 bolt round pattern GM205 can be clocked with out a clocking ring...can you just rotate it one hole? If not where can i get a ring and also if so how much will it drop the front output...i have driveshaft issues so i need the most drop possible....and also will it make my driveshaft go sidesways(im sure it will a little which is no big deal).

???

try searching for user name D.D. Machine in the for sale section keywords clocking ring

the holes are not evenly spaced. so no, you can't do it without a clocking ring,

it would clock it up so far into your floor board you'ld be useing it as a seat mount.

you would have to completely re-design your shifter.

i doubt your cvc or drive shaft would handle that much change.

it not a horrible idea, its just more than is allowable to work feasably. the clocking rings are not that expensive and only go abotu 1/2 that amount or rotation which is plenty.

CK venders they run about $ 55-60 or D.D machine has them to good luck

as said check vendors BUT im not 100% sure but I do believe they are designed to clock up and not down..