|
Chief yelling alot 06-22-2002, 05:43 PM yup 79 frame and body traveler the guy keeping the axels and e-fercase and moter andi get the auto so uh how do I fit full with axels under this thing how do I know where to put the new spring pads? Mechanos 06-22-2002, 09:26 PM Originally posted by Chief Yelling Alot yup 79 frame and body traveler the guy keeping the axels and e-fercase and moter andi get the auto so uh how do I fit full with axels under this thing how do I know where to put the new spring pads? Put them directly under the springs :flipoff2: preferably with the axle centered under the truck. mike 06-22-2002, 09:36 PM Tape measures, they work. Amazing ;) Chief yelling alot 06-22-2002, 11:33 PM so do I mesure from the backing plate or from the pumken wold that work being that its slightly off set mike 06-23-2002, 12:52 AM I always measure from WMS Chief yelling alot 06-23-2002, 09:07 AM hmm that might work but I dont know how much wider the full size is but i'll see if i can get an acurate reeding BTW it's a 76 not a 78 some one change the grill mike 06-23-2002, 03:24 PM Okay. Measure the whole axle measure the width between your springs then subtract that width from the axle width divide by two put that on either side of the spring on center. BTW thats not a "might work" thats a guaranteed to work. It really doesnt matter where the old perches were, in fact cut the things off so you dont worry about trival stuff anymore :D Chief yelling alot 06-23-2002, 08:10 PM grate thanks does it mater if one mesured from backing plate or WMS? mike 06-23-2002, 08:11 PM Nope, since the backing plates a constant as well. Chief yelling alot 06-24-2002, 11:18 AM cool :cool: | |