Both shafts were built by High Angle Driveline. the front is a 42 degree cv unit with 1410 joints on both ends. and the rear is 1410 joints on both ends. All joints are tight. The rear shaft measures compressed this is 67 inches long and extended it is 71.5 inches long. and the front measurements from the mounting flange are as followes, 23.5 inches compressed, and 27.5 inches fully extended. I will include the flange which is for an np205 tcase.

I would like to get $450 obo out of the front. and $200 obo out of the rear. Plus Shipping.

Pm with questions or anything. I really want these gone so I can get parts for my race truck.

I also have a Dana 60 front axle that is out of an 89 f350, complete from hub to hub with trac bar and all steering. I have $850 in it, lookin to get $700, buyer would be pay freight, I can deliver within 200 miles of zip 14712 in western NY. I would also like to get rid of this before the snow hits too hard. I am also taking offers on this, I'm gunna take a hit, but I dont have the room.

All parts are located in Western Ny about an hour south of buffalo. Zip 14712.

Thanks for looking.

I'll let anyone Know that I can- Jess

ttt for a good deal

so everyone knows, there is nothing wrong with the High angle Drivelines stuff, I'm gettin out of the big truck field for a while and just dont have a need for these, they are of top quality and there are none better out there. someone will wind up with a top quality set of shafts.

bump

is the flange bolt pattern for the front shaft the same as a 1350 pattern would be?