|
Bgcj5 06-23-2002, 08:18 PM For all of u that have wired your 5.0's I have some questions. I need to identify the following wires and plugs. Thanks for your imput. Any tips as to what u did would be very help full. Bgcj5 06-23-2002, 08:19 PM More Bgcj5 06-23-2002, 08:20 PM Another Bgcj5 06-23-2002, 08:23 PM This last pic I need to identify which fuel rail is the sending and return. Thanks Sillyneck 06-23-2002, 09:24 PM 1st pic far left is fuel pump wires and maybe speed sensor too can't remember. and the silver thing looks like your ignition relay. the little black one is your ground strap. the stuff by the coil all looks like it needs B+ that's all I know TNToy 06-23-2002, 11:44 PM Originally posted by Sillyneck that's all I know I bet you know one more thing: He should labeled them as he removed them from the donor. :flipoff2: Rock Puppy 06-24-2002, 07:19 AM Try using this Guys Page he has the Diagrams and the layouts.. http://mybronco2.com/info.htm John Deere Ranger 06-24-2002, 09:54 AM i'm in the process of the same thing here is a good link http://77cj.littlekeylime.com/5_0l_wiring.html IronBenderII 06-24-2002, 09:56 AM Don't assume anything!!!!!! Go to Ford and get the FMS wiring diagram for their SEFI conversion. It is based off of a 93, which is a bit diffent from the 88-92, but it's really close. It shows each connector and what wires go where. Trust me, you will get screwed and fry your computer if you don't have everything perfect. Don't ask me how I know (man those computers are expensive when you have to buy them twice). -Jack John Deere Ranger 06-24-2002, 09:58 AM on the second piture on the bottom is a ground plug, and above that is another ground plug and the final empty plug is for the A/C The third pic it is unclear to me what plug you are wanting but you have some sensor plugs there that seem to be already pluged in. You also have the A/C condensor plug right there too (the plug at the tip of your fingers) Bgcj5 06-24-2002, 07:31 PM Thank you for the replies. I am very greatfull they have helped a lot. AGGIECJ-7 06-24-2002, 07:34 PM on my truck with the 5.0 EFI in it, the driverside rail is the intake and the passenger side is the return...but dont quote me on that.... Mr.N 06-24-2002, 07:52 PM Originally posted by dangerranger33 i'm in the process of the same thing here is a good link http://77cj.littlekeylime.com/5_0l_wiring.html Hoped the page helped. Any Questions? Edit: ->The Bronco picture page is a scan of the Probst Pamphlet, Good info to know! Just view it before Ford does ;) Mr.N 06-24-2002, 08:03 PM Originally posted by Bgcj5 For all of u that have wired your 5.0's I have some questions http://www.pirate4x4.com/forum/attachment.php?s=&postid=649461 Note: You'll want to mount the computer plug down. It lets any water / condensation drain out. | |