randii
06-26-2002, 11:12 AM
Anybody know where to get these for cheap -- gotta be kingpin-style?
Hmmm... mebbe I'll just buy a whole 60, dremel off the ends, and recycle the rest for scrap. :p
...or maybe someone fabs these up? Wagoner Machines does excellent work, but their prices make the above choice look pretty attractive!
Randii
SeaBass44
06-26-2002, 11:19 AM
try dynatrac or a dana/spicer dealer, not sure how much $$ are you making a toy/60? spill the beans!:p
Aggro
06-26-2002, 11:28 AM
dynatrac only does balljoint style. you could find some here! (http://www.pirate4x4.com/forum/showthread.php?s=&threadid=54652) new lower price too!!!
randii
06-26-2002, 04:13 PM
...are you making a toy/60? spill the beans!:p
No beans... just helping with a repair...
SonoraBob
06-26-2002, 05:33 PM
PartsMike. I think for $189 a pair.
I see them come up on eBay from time to time too...
Then again - I have found that I could just about buy a complete 60 front for a grand and sell it in parts on eBay and double my money :shaking:
Old Scout
06-26-2002, 06:02 PM
Originally posted by Bob/CA
PartsMike. I think for $189 a pair.
There for ball joints!
Andy West
06-26-2002, 06:51 PM
Originally posted by randii
Anybody know where to get these for cheap -- gotta be kingpin-style?
Hmmm... mebbe I'll just buy a whole 60, dremel off the ends, and recycle the rest for scrap. :p
...or maybe someone fabs these up? Wagoner Machines does excellent work, but their prices make the above choice look pretty attractive!
Randii
I am going to cut a set off of an axle soon, could be sooner, I have. It's a 90 model HP 60 with kingpins. I would be interested in trading for gears for this axle 4.10 to 4.56, spicer, and, or a full spool for a 60. Prefer the gears. Are you interested? Andy
doctor_G
06-26-2002, 07:11 PM
I have a pair off the tubes.
Was going to keep around for spares but, It's unlikely I'll need them. They are the king pin style.
I would consider selling or trading for parts.
Oh and Andy West, I'll have to check but I might have a good 4.10 ring and pinion for RC60
SonoraBob
06-26-2002, 07:16 PM
How can you tell if it is kingpin? Pics?
lt1yj
06-26-2002, 08:12 PM
I have a complete set of tubes for a '79 Ford RC 60 king pin.
The upper king pin on one side needs to be replaced. It's already loose (they thread in) and Dynatrac sells replacements for them if needed.
$100 for both tubes/C castings.
4:10 R&P w carrier $50 also RC60.
Email if interested.
Andy West
06-27-2002, 02:59 AM
I sent email, Thanks, Andy
SonoraBob
06-27-2002, 03:39 PM
PartsMike sells kingpin parts, not ball joints. So how can you tell if it is a kingpin or balljoint?
Dan-H
06-27-2002, 04:45 PM
randii,
step away from the other rig and get back under your own
the clock is ticking.
You have 41 days... :flipoff2: