I need new shafts due swapping most every drivetrain part.
I don't want to spend the $$ on shafts from High Angle until I have all the bugs worked out - axle placement etc. What shops are good and reasonable on prices?

Someone recommended The Offroad Shop. Any suggestions.

Thanks,

Ryan

Check out Arlington 4 wheel drive!

stay the hell away from the drive shaft place located on jefferson [ in grand prarie]across from the junk yards, they don't know dick. i had them shorten a shaft for me and screwed it up good . to tell you the truth i don't think they can even balance one. i think it was mid citys drive shaft but im not 100% sure so i don't want to hammer the name.mike

Automotive Driveline Supply 817-284-8187, located in Ft. Worth.

fort worth gear and axle
3409 kelli ct.
fort worth tx 76106

If you don't get it right the first time Jess will work with you on fixing the problem.

I have had to send back mistakes to Jess, and if he could reuse the stuff, he would give me full credit!

I would go big and go the best on the first shot....

High Angle Driveline is :smokin:

I'm going big to start with! After pricing some of these other guys I'm getting one from Jesse with a 1350 CV and a 1410 yoke on the 60. Just need my ORD Doubler to get here so I can measure for it.

Thanks for everyone's input,

Ryan

Yeah I am waiting on getting my ORD doubler also and also my rockwells but I am definitely going highangle. I am having him build me a front w/ a carrier bearing and a rear CV more than likely. I have seen the 1410s on elflosers rig and I want them.

Go high Angle unless you wanna get fawked.:beer: