Lifted my bronco 3 inches(XJ coils) and now the drive shaft and cross member are closer neighbors than I need them too be.
Any one have pics of c notching or any other options, Besides lowering the whole Xmember.

I'm assuming you mean the one under the trans bell. Other than going long arms and deleting this cross member, a custom one is needed.

Radius arm drop brakets from an STX ranger with the highrider package... or get aftermarket drops. Or make some. You need to drop the radius arm pivot mounts down.

since u lifted it 3" im sure ur radius arms are on a horible angle. all u need to do is drop down the x-member 3-4" personally since u have to move it take it off and make some long arms from ur stock radius arms. ull have better flex and a better angle on the radius arm(parallel to ground). Later Mike

Horse shit
Put it back together last night with taller F150 springs and every things fine,Even the driveshaft.
This offroad only,not worried about alignment ....:flipoff2: