I've been looking everywhere for a yoke that will fit my 30 spline 205 that is NOT a cv style yoke. I was told that there is an "adapter" that will allow you to do this on the front output but i can't find it anywhere. Any help or suggestions would be great. I don't want to run a cv driveshaft because they are so costly and i don't know much about them. Thanks for your time.

it was rare but there was a 1310 c/v style end yoke 1 tear and real expensive- also there are other ways of making a flange to a single joint - non c/v - give me a call- what series you wanting ? and how much angle needed? JESS 530-877-2875