JUST GOT THEM UPLOADED TO MY SITE- ! go check em out- Jess

For the lazy <IMG SRC="smilies/biggrin.gif" border="0"> <IMG SRC="smilies/biggrin.gif" border="0"> <IMG SRC="smilies/biggrin.gif" border="0">

http://www.highangledriveline.com/00_00004.jpg

How Much I need Spare's hehehehehe

might as Well get the best with the 35 spline outers <IMG SRC="smilies/biggrin.gif" border="0">

Adam

,PM me Jess ,,,,Thanks

hmm i gots a question for you, off well i quess i will call yo uinstead

So are these working now and for sale?

If so, what are you asking???

What are the prices and how much stronger are they?

Same as above. <IMG SRC="smilies/bounce.gif" border="0"> <IMG SRC="smilies/bounce.gif" border="0"> <IMG SRC="smilies/bounce.gif" border="0">

What alloy are the stock ones made of, and what kind of heat treating do they have?
Just curious.

[ 09-05-2001: Message edited by: Drew Persson ]

just curious but seeing as how it is a square cross section would it be beneficial to radius or curve the edges to releave stress?
later
bob

Only the body is square. The journals all have .060" radius in the corner. That is more than the stock ujoint have.

this joint above will be tested on a rear steer 60 to see how it holds up- just wanted to show you all what we are working on - and that we are not sittin on our buts about the dana 44 issue - when we get the 44 joint in it will be a race to see how they hold up- we will keep ya posted- pricing to follow-Jess