I was told these will just laugh at my 22r and all my gearing :shaking:

I just can't find any axle bearings that will work. They fit fairly tight without bearings , Do you guys think I'll have any issues if I ran without bearings, just greasing them up and running an extra quart of gear oil?

:laughing:

Dude, wrong forum. We do not want to see a pic of your greased shaft.:homer:

You don't have a hair on your ass if you don't run those things!













:flipoff2:

Broach a v6 carrier to 35 spline, neck those down to 35 spline, and then run the housing ends from....whateverthehellusesthatmassivesemifloaters haft!!

I'm guessing there full floaters from a dumptruck or Semi truck. Brought in some scrap from the shop and saw it sitting in the scrap pile. I'm goign to use it to make some blacksmithing tools :)

Just use some needle bearing from some U joint caps :)