ok so whats the shaft size and thread tpi on the factory '74 tierod end ?

Chuck it, it's a weak POS.
ES150L and ES150R are the same taper.

well i really wanted to know the shaft size and thread TPI cause- if i can - find a hiem to run in the stock tierod and run my drag link through the same bolt.

wait wait, you are going to put a bolt through the tapered hole in the knuckle?

if you are making a new drag link anway, why not just make a new tie rod at the same time. it's prolly worn out as is.

Take it to a hardware store and find a nut that fits, then you know.

9/16"-18 or 5/8"-18

It took me 2 mins of searching. You smell of newb.

rockauto.com for the part number, google for this spread sheet.

http://72.14.235.104/search?q=cache:qt4rq0DWjdEJ:www.locostusa.com/yahoo/MoogBallJts.xls+ES392L+thread&hl=en&ct=clnk&cd=1&gl=us

It took me 2 mins of searching. You smell of newb.

Sig material right there.:flipoff2:

well i really wanted to know the shaft size and thread TPI cause- if i can - find a hiem to run in the stock tierod and run my drag link through the same bolt.

but the stock tie rod is a weak POS. :shaking:

well i really wanted to know the shaft size and thread TPI cause- if i can - find a hiem to run in the stock tierod and run my drag link through the same bolt.

Yeah, run both steering parts through 1 bolt in single shear set up :shaking: Thats ok, your tie rod will probably fold before the bolt folds over.

ok, so i found out what i wanted and realized some of you shitheads huff paint as a favorite pastime. i personally dont give a fuck what you think of my setup or did i even ask about your view of it, but just keep wastin away at those pitty key strokes cause this is only PBB not Jerry Springer :flipoff2:

:laughing::laughing:

ok, so i found out what i wanted and realized some of you shitheads huff paint as a favorite pastime. i personally dont give a fuck what you think of my setup or did i even ask about your view of it, but just keep wastin away at those pitty key strokes cause this is only PBB not Jerry Springer :flipoff2:

Hey dick knuckle, you wandered into OUR forum like a lost little girl. You ask a question about a questionable steering set up at best. What did you expect? Do us a favor and try out a dynamite tampon.

:)

Why even ask here? The Jeep forum has more info on ScoutII axles than the IHC forum :shaking::shaking: