|
hybrid 07-04-2002, 08:39 PM I'm needin the pin out for the trany controler. It suposedly came out of a 98 cherokee, AW4. Factory manual shows a differant connector... Help. Here is what the connector I have looks like. Thanks, Mike Little_TJ 07-05-2002, 05:45 AM I have the 98 electronics manual. I will try and scan it for you beforre I leave on holidays Monday. If not I'll get it to you in a couple of weeks.:) hybrid 07-06-2002, 12:11 PM Found it.... Tempe Public Library Mitchell online. Turns out it came out of a 97 SE. Now that I know the pinout, it's time to put this AW4 into a YJ. BillaVista 07-06-2002, 03:51 PM Hybrid.... an AW4 in a YJ eh? very interesting. What WB? What length rear shaft do you end up with? hybrid 07-06-2002, 07:45 PM I have a slip yolk eliminator so I gain a bit there, Spring over +1" shackle lift another gain, will loose 1.5" in tranny length and lost more at the pinion for my D44 that just went in. So :beer: I don't know. I expect I'll just move the rear axle back the 1.5 - 2" so I don't have to make another drive shaft, but I will if need be. The front is pushed forward 1.75"+96"stock+~2"=~99" | |