Im swapping in scout danna 44s into a samuari, sprung over with cj springs..
Im cuttig and turning the yokes so im not quite sure what angle to set them at.. If i should set them at zero or down a couple deggres or up?
Any help appreciated.
Im also going to be running high steer if that changes anything..

With the weight on the springs and sitting on a flat surface I would set the caster at 6deg. With a scout 44 this will put the pinion sort of low due to the way scout had them put together but that is just the way it is.

i set my old scout 44 to 8degrees and it worked great.

7 deg

some one had to say it.

any way shoot for 7 if it moves a little
during the welding process tou will be ok