It my constant rig build ADD, I've decided to look at a front 609.

The one thing I can't figure out is how can I get it to be close to full width (69.25")?
They come in at 65" with a centered housing, so I'm assuming you have to cut and add tubing, then when you add Cs, knuckles, brakes, hubs, etc. I'd like it to total out to 69.25".

Any help?

I have written it down somewhere when I was doing some research but when I called SOLID they told me what the width of the knuckle assembly was to use for my measurements...

Any of the reputable knuckle builders can tell you...

JOSH

Thanks.

Any other help?

I assume you're looking at the spidertrax housing? You realize that with the inner c's, knuckles, brakes and spindles added to a 65" housing, it will be well over 69"...

Which is the nice thing about Spidertrax, I can cut it down. Just not sure what to do since the driver side will be shorter.

D60 C to WMS is 12" I belive..working on a 609 for a EB..58.75 WMS:eek:I will have about 2" of drivers tube.

Cary