im about to make the tool to turn the adjusters on the 8.25. does anyone know the the exact size of the head(hexagon piece). the more exact the better

thanks.

I used a 1 1/2 inch nut, tapered down to 1 3/8 to feed into the hex adjuster a little easier. It's welded to a cheapie socket and extension.

i got a tool from my matco tool guy that uses a 9/16 wrench on the outsiide for like $40. if you want to drive to NJ i will let you borrow it

This was just discussed in the Cherokee section (http://pirate4x4.com/forum/showthread.php?t=657069).

Its a 36mm nut ,you can take a spare front hub nut and weld it to a long extension.You make make your own tool with hub nut,some small stock and an old socket.