4L60E transmission is out of a 2000 camaro. It had 37k miles on it when bought. The transmission was rebuilt and has a 4wd tail shaft (same as a 4wd tranny now). It also has a new 13 vain pump. It has 12k miles since being rebuilt. The adapters below were used to bolt a dana 300 to it. The tranny is still on the LS1 until sold. $450


Advanced Adapters (P/N 50-6309) GM 4wd 700R4 & 4L60 to Jeep Dana 300 Adapter Kit. The gasket, fastening hardware (studs) were left on the dana 300 when it got sold. The studs on a dana 300 will work fine. $350 SOLD

Advanced Adapters (P/N 50-0405) GM 4L60E 6 to 4 bolt Converter Plate (the reluctor ring sensor plastic at the plug is chipped off, still works) $150 SOLD

Spartanburg, SC

ttt

do you know if this will work for the stak 300? thanks

do you know if this will work for the stak 300? thanks

yes

it allows a d300 or any other TC that has the bolt pattern and input splines as a d300. stack, atlas, stak 300, d300

ttt

The remaining adapter will bolt a Dana 300 up to the 4L60E, or was that the adapter that is sold?

The remaining adapter will bolt a Dana 300 up to the 4L60E, or was that the adapter that is sold?

the adapter i have left changes the 6 bolt pattern on the back of the 4L60E to a 4 bolt pattern like the early 4L60 and the 700r4

still have the 4L60E