I'm using a Waggy inverted T setup and was wanting to know of a part number or model of vehicle that uses a 7/8-18 thread on the draglink end with the same taper for the pitman arm of YJ's and XJ's. I'm running a RC HP 44 in my XJ and need to finish the steering....headed to Tellico for next weekend!!:D

I've read your post three times :confused: , but I'll take a stab at it. You might be looking for a Grand Waggy pitman, it has the large taper.

No...I'm wanting to use the pitman arm that I now have and find a tie rod,,or I should say a drag link end that has the small taper and a 7/8-18 thread to fir my drag link.

so are you wanting to ream your pitman arm out, if so Just get a stock waggy arm, but Im not sure I understand your post.:confused:

sounds to me like he wants a "small taper" rod end with a 7/8 thread. Not the "big taper" like the waggy arm.

Yes..like Rustywhite said...I want a small taper with a 7/8 end on the non taper part. If not what and where do I get a reamer?

I looked thru the moog catalog and there's nothing smaller than (0.594/0.703) taper with 7/8 shank. Most have a bend in them. Parts Mike sells reamed pitman arms for the big taper 7/8" TRE.

Jekyll...what is the part number on the one with a .594 end of taper...that's what I need.

ES437L- (0.594/0.703) has a stud length of 0.0.872. it is bent. 3.95" long.

There's also:

ES454L- (0.612/0.703) stud length 0.728 . straight - 4.0" long

ES380 L & R - (0.612/0.703) stud length 0.728. straight - 5.56" long.