yager
07-08-2002, 09:14 PM
Hey all, since my project is dragging on i decided to add more of phase 3 to existing work.
Ive searched on tube frames and cages and most seem to all use the existing frame rail most of the way back then go tube.
Id like to hear some input/ideas on how to best tie in the rear tube AND section and raise the main frame rail under the cab (seat area back)
While watching many vehicles this past weekend they all got hung in the same spots, the outter edge of the frame rail.
The seats sit up a few inches and my exhaust is already tucked up some along with the flat skid... my idea is...
Raise the frame rails and make the tcase drop in from the top, tus removing all the hassles of remove skids etc. Allow easier access etc... The seats would be attach to removable points to allow for easy access.
Ideas, suggestions im mainly searching for ideas on how to best brace triangulate the rear to the front.... ill post a pic up in a few min... of what i have so far...
-yag
Ive searched on tube frames and cages and most seem to all use the existing frame rail most of the way back then go tube.
Id like to hear some input/ideas on how to best tie in the rear tube AND section and raise the main frame rail under the cab (seat area back)
While watching many vehicles this past weekend they all got hung in the same spots, the outter edge of the frame rail.
The seats sit up a few inches and my exhaust is already tucked up some along with the flat skid... my idea is...
Raise the frame rails and make the tcase drop in from the top, tus removing all the hassles of remove skids etc. Allow easier access etc... The seats would be attach to removable points to allow for easy access.
Ideas, suggestions im mainly searching for ideas on how to best brace triangulate the rear to the front.... ill post a pic up in a few min... of what i have so far...
-yag