|
85toyboy 11-03-2001, 03:06 PM what type of puller do you use to seperated the carrier bearings from the carrier on a rearend? I'm trying to change gears on a Ford 8.8 rearend. Is there some special puller to get the bearings off the carrier? I have a 2 arm puller but what do you put the middle shaft on? JIM3030 11-03-2001, 05:23 PM you got it. just make something to fit in there. just smaller than the id of the bearing 85toyboy 11-03-2001, 09:52 PM I tried a dowel, but it wont allow enough pressure to remove the bearing. Anyone else got some ideas? What did you put in the axle hole? SNORTclown 11-03-2001, 10:11 PM tourch and grind a peice of 3/8" plate. tipover 11-03-2001, 10:20 PM go to harbor frieght and by a $120.00 press! CJBoxer 11-04-2001, 07:54 AM This is what I use. http://dreamwater.com/zuk/dana44toolaid.html Thanks zuk. | |