Alright guys I sheared 2 bolts off on my transfer case mount so I disconnected all the drive lines took the tcase down got rid of the bolts and put the tcase back up.... So I put it in 4 low and creep around my house for a while and it seemed fine....so later on I left but forgot to unlock the hubs:eek: So I start going down the road and it starts vibrating and after about 15-20 miles of highway driving the vibrating gets worse so I pull over to see wtf is wrong?? and everything was solid underneath then I noticed that I forgot to unlock my hubs. So I unlocked them and drove for about 10 more miles and the vibrating just keeps getting worse and worse. So I know it is bad to drive on the highway with your hubs locked but are they screwed now? or is it that I just screwed up with installing everything back in.... Everything is solid except for the rear driveshaft where it goes into the axle but that was even loose before I took the tcase out and it didnt drive like this?? So any suggestions on stuff I can do or just ideas would help, Man after being out for a couple of weeks I thought I was finally gonna get some wheeling done:mad2: :rasta: Thanks guys!!!

as long as your not in 4wd it's not that bad to drive w/hubs locked. sounds like your axle flange is bent or maybe a bad u- joint.

When you took the t-case off did you replace the bolts, and if so, are they tight.
(this is a silly answer)also look if any weights are missing off your drivelines, they might be out of balnce and cause the vibration

BTW it's relly hard to fuckup a aisin hub;)

When you are flat towing with the t-case in nuetral, the front and rear drive shafts spin. Sounds like you have a u-joint going out. If you want to isolate the problem, do this:

1. Tow a short distance with t-case in two wheel drive. This will turn rear shaft only, if it vibrates, there's your problem. If not, the problem is probably the u-joints in the front shaft.

Whaen you pulled the shafts, did you seperate the drive shafts?

like john said, if you pulled the shaft apart, did you put it back together so that the two u-joints are lined up right????? i did that before and it had vibs.....
:flipoff2:

Ok I think that might be my problem guys, I did pull apart the rear driveshaft and did not realign the ujoints, going out to see if this works thanks a lot guys.