I am trying to build my truck on somewhat of a budget so i scored on a late 60's ford f250 (freebie) and wanted to use the ibeams off it. Any suggestions on what I should alter and some common issues with this swap, I am already gonna use heims on the ends but should I bend them and how much? And if so what the best way to bend them? In a bender or use a little heat? Just thougt I would ask. Also the truck has a Dana 60 rear, use it or save for something else and go for the nine inch. Thanks for the help.:D

I dont know but look at gaint. they had a bad ass toy ibeam they where building

i put beams on a nissan hardbody. it wasent that difficult.