Im getting ready to swap in my 60 in the rear. How do weld the perches on, so that the pinon is perfect. Is there a way to measure this..

Angle Finder At Ace hardware Or Home Depot Or welder Supply Has Them!!!!!


Adam,,,,,

I think the best way is to put the axle in the rig with the weight on the axle and the ubolts a bit loose so you can rotate the axle to really figure out what the ideal position is for your rig. I think that's the way most shops do it.

hope this helps.

[ 10-02-2001: Message edited by: morpheus ]