|
: Steel Degree Shims... Blue Torch FabWorks BlueTorch 03-18-2008, 11:28 AM If you need degree shims be sure to check them out on our website at the following link: http://bluetorchfab.com/store/index.php?cPath=60_18 We currently have 2.5, 4, and 6 degree in stock. They are sold in pairs. Thanks Dan BlueTorch 03-20-2008, 08:55 PM we are getting ready to make a run of 8 degree if anyone needs them. We have a couple people asking for them so we are going to put them in the line up. All of the shims we sell are machined from steel plate. =Dan BlueTorch 04-02-2008, 03:39 PM http://www.bluetorchfab.com/images/we_moving.gif BlueTorch 09-25-2008, 10:06 AM to the top. we stock steel shims only,,,, 94toytruck 09-25-2008, 11:38 AM How long are these shims Dan? redranger4.0 09-25-2008, 11:50 AM How long are these shims Dan? x2 I would like to know too, I have 7" long or so spring pads, so I would like a shim thats longer then most others. BlueTorch 09-25-2008, 05:14 PM The shims measure 5 inches long and 2.5 inches wide. guidolyons 09-25-2008, 07:23 PM Dan, I need some 8* shims. Do you still have some? Shipped to 66027, Thx 94toytruck 09-25-2008, 07:35 PM The shims measure 5 inches long and 2.5 inches wide. Can you make some shims if I give you dimensions? My perchs are 7 inchs long and pins are offset 1.25 off center. BlueTorch 09-26-2008, 11:05 AM Can you make some shims if I give you dimensions? My perchs are 7 inchs long and pins are offset 1.25 off center. I can make a one off set but you might not wanna pay for them. PM me a number to call you. I will call you Monday when I get back to the shop. Dan BlueTorch 09-26-2008, 11:06 AM Dan, I need some 8* shims. Do you still have some? Shipped to 66027, Thx I have a friend that has a few on the shelf. I can get them to you for the same price as the ones on our site plus shipping. Dan redranger4.0 09-29-2008, 09:26 PM I can make a one off set but you might not wanna pay for them. PM me a number to call you. I will call you Monday when I get back to the shop. Dan Can I get a rough estimate on a 7" long shim? 94toytruck 09-29-2008, 09:57 PM Dam I forgot all about this post. I need basicly the same 7 inch long shim 2.5 wide. I'll punch the holes myself. They are actually the same dimnesions as the interlocking axle perch's I got from you guys. Mauler 10-02-2008, 11:01 AM Do you have any of the 6* that are 2" wide? I suppose I could chop down the 2.5" wide ones if need be. Please PM me a cost for a pair (2" or 2.5") shipped to Napanee, ON K7R3K8. Thanks. | |