Need a D60 Re-tubed in Phoenix

[ChicagoDII]

Basically, what the title says. I need to find a shop, or someone, in Phoenix, Tucson, or anywhere in AZ really, that can re-tube a D60 for me at a reasonable price.

[Gen. Nonsense]

Just saw this thread. I feel that I must add this in. I got fucked over by Todd too. He is a liar, a theif, and an asshole. Do not do business with this guy, he will fuck you over, period.

Well I guess Desert Fab is out of the question.... :flipoff2:

[Westy]

Try Randy Ellis Design in PHX - 602-803-1122
2855 W. Fairmount Ave PHX, AZ

[el ranger loco]

Try Randy Ellis Design in PHX - 602-803-1122
2855 W. Fairmount Ave PHX, AZ

Ya, if he wants a light bar! :flipoff2:

How about hoppers.. Dont be fooled by the name. The "rock hopper" is a turbo'd small block buggy on 42s:D

Hopper's Automotive
2003 E Apache Blvd
Tempe AZ
85281-4821
480-967-8677

[ChicagoDII]

Well I guess Desert Fab is out of the question.... :flipoff2:

Ha, ya no kidding. Fuck Todd and his shit. That asshole cut .5" into a $300 forged front radius arm with an angle grinder to try to make the draglink on my truck fit. That and he fucked up just about every bracket and weld on my axle swap. If I ever see him again, I'll cut his fucking balls off.


Anyone ever used David at Arizona Differential Specialists? He just quoted me $250 for labor and tube. I have a ford 3rd and knuckles already removed from the tubes.

[87mobber]

you might try phoenix rack and axle, or ask randy ellis if he knows of anyone....

also AZrockcrawler on the board might know of someone who could do it

[howyadoin]

Ya, if he wants a light bar! :flipoff2:

How about hoppers.. Dont be fooled by the name. The "rock hopper" is a turbo'd small block buggy on 42s:D

Hopper's Automotive
2003 E Apache Blvd
Tempe AZ
85281-4821
480-967-8677

x2 on this...

[ChicagoDII]

x2 on this...

I called Hopper's (who is less than 2 blocks from my house) and he said he has never re-tubed a D60 and wont take the job. He says he has only done cut and turns.

[el ranger loco]

Didnt see that coming! Any experienced fab guy can do it..

[lostoffroad]

what specs do you want it tubed to? are you looking at building a stock width 60 or custom? if you already have the c's and the center section cleaned up and ready it shouldnt be a big deal. just press in the new ones and weld the plugs. done.