I am currently working on putting a cage on my truck. I've got a few bar's bent but cant quite figure out how i want to finish it. So i turn to pirate for ideas!
Give me some ideas:
http://forums.minnesotamud.com/gallery/images/107/large/1_Truck_085.jpg
http://forums.minnesotamud.com/gallery/images/107/large/1_Truck_086.jpg

here is what i was thinking:
http://forums.minnesotamud.com/gallery/images/107/large/1_Truck_084.jpg
http://forums.minnesotamud.com/gallery/images/107/large/1_Truck_083.jpg

This is only the rear of the cage, it's gonna have a complete in cab cage that connects to the rear part of the cage.

thanks.

looks pretty tough

I like it.

are you not planning on having a bed on your truck?

idea looks good, just make sure everything is triangulated.

Looks Good

I use tape all the time for refference as tube. It gives you a good idea how its going to look if you cant decide on something. I like it, keep it going.

Thanks for all the replies. looks like ill what i was thinking for a design then.

Any plans to link it with CO's? If so maybe some tubing that ties in a little further outboard to use as mounting point for suspension components. So far everything is sucked into the center....good for tire clearance, but with leaves you won't need to worry about that..... :)

I've always liked the looks of this rig...