|
Josh 10-06-2001, 10:47 PM OK, I deleted my last post after being told there was a article in the tech section for this. However, that was to mate a NP203 to a stock Land Cruiser case. I am going to mate a NP203 to a NP205 and was wondering if there was a cheaper way other then the near $1000.00 for what ORD wants. Or if someone has the fab ability I will pay them for the adapter. webilt 10-06-2001, 10:54 PM how about a divorced 205?, behind what ever you have now,, granted they only have a 1.98 to 1 low range,but should be pretty good with both cases in low ,I think the wrecking yards (around here)No.Cal. get about $150, to $200 for one,, and then all you'll need is a crossmember, and a short driveline in between,!!! Josh 10-06-2001, 11:02 PM Right now I have a SBC 350/TH350tranny and a NP203 and just aquired a NP205. The above are mounted in my FJ55 with the exception of the NP205 (that's where the doubler comes in). [ 10-06-2001: Message edited by: Josh ] AIRZUKI 10-07-2001, 01:59 AM bc4x4.com has an article on doing exactly this swap Gord Pritchard has dual cases in his FJ45 pickup.HOW TO DOUBLE UP! (http://bc4x4.com/tech/2000/gordtcases/gordtcases.cfm) [ 10-07-2001: Message edited by: AIRZUKI ] | |