well i was wondering if someone has the complete breakdown on a web site, or knows someone who does, to help me swap 4:10's into a 87 ish BII, this is going into my bosses truck, he has 3:73's, but had a 9" lying around with 4:10's and a trac lock, so we are swaping that into the rear, and have to change the front gears, we have the 4:10's setup in the alluminum housing, now who has swapped this in and can give me the run down or help me out, he said i had to have a detailed breakdown on the swap before i started. all from removing the auto hubs. axles etc, and if anyone knows a good manual i could look at to help this swap that would be good to.

:confused:

well over on the RRORC board id tell you to go to
www.therangerstation but here i will tell ya to rip it all out and put in a D44 straight axle :D to match the rear :eek: :beer:

well if you wanan buy a 4.10 D28 axle complete lemme know dangerranger33@hotmail.com

but as for the swap it self......

jack up, remove tires, unbolt old Pumpkin, split passanger side shaft in two then slide the pumpkin out... remove c-clip then reverse and add gear oil.... yep pretty much that simple... done it my self in under 1:30 with:beer: and :smokin: brakes.

Originally posted by dangerranger33
well if you wanan buy a 4.10 D28 axle complete lemme know dangerranger33@hotmail.com

but as for the swap it self......

jack up, remove tires, unbolt old Pumpkin, split passanger side shaft in two then slide the pumpkin out... remove c-clip then reverse and add gear oil.... yep pretty much that simple... done it my self in under 1:30 with:beer: and :smokin: brakes.


HAHAHA i wont get those kinda brakes at work, well thanx for the help, i posted over there 2. and we have an axle with 4:10's aready thanx anyway