Jess,
Im interested in a slip yoke kit for a yj NP231 along with a driveshaft... here is my dilemma... my yj is my daily driver, so it can't be down for more than one day... if that.... So Im curious.. a buddy of mine said Tom Woods did this for him, and I was curious to know if you were able to do the same... either way, I want a kit from you but.... here is the deal.. If I were to give you the amount of lift, which SYE I was running, which rear axle I was running, and which tranny I was running, would it be possible to get a shaft ahead of time from you, so I can put it all together at once, and not have my daily driver down while Im waiting for a driveshaft? Also, how much is a JB NP231 SYE and driveshaft combo? Thanks!
Scott <IMG SRC="smilies/grinpimp.gif" border="0"><><

I think he can do it if he gets a mesurement from the face of the seal to the center of the pinion yoke.

TPI, thanks for the info, Im gonna see if Jess responds, because I also need to know how much an SYE and DS combo will run me .. by the way, I love the way your CJ turned out..
Scott <IMG SRC="smilies/grinpimp.gif" border="0"><><

BTT for Jess!
Scott <IMG SRC="smilies/grinpimp.gif" border="0"><><

well i should be able to do this as long as you can measure your existing shaft weld to weld and tell me if its running short or not- or take a pic and send it if your not sure- give me call- 530-877-2875 pricing is 550.00 outright no core for the driveline and kit- Jess

[ 10-03-2001: Message edited by: onetoncv ]

Damn did the PM's stop working to.....

<IMG SRC="smilies/rolleyes.gif" border="0">

<IMG SRC="smilies/thefinger.gif" border="0">