finally located a clean standard bore 69` windsor block to build my 408" stroker.i`ll be running a forged crank,rods,pistons.
i have a set of ported canfield heads and the full roller setup.motor will be fuel injected using gt40 intake,75mm throttle body,80mm maf,42lb injectors,1/2 billet fuel rails and a vortech t-rex pump regulated around 40-45psi. just not sure on which cam to run?? prefer CRANE cams what do you guys recommend for a pre running, rock crawlin, sand duning(i have a full set of paddles for it), beast of a motor??? motor most likely will never see over 6000rpm. trying not to lose to much bottom end.

list bore and stroke, valve sizes, exhaust manifold type, etc, and I'll fiddle with the desktop dyno to see what it comes up with.

30 over on the bore,4.00 stroke, 205 intake 164 exhaust, gt40 ported intake,jba shorty headers(1 5/8 primaries to a 2 1/2?) all running into a single 3" pipe.