|
Wilson 05-04-2008, 02:25 PM I bought some new Al heads for my cruiser and am installing them. I'm replacing the studs/bolts with ARP hardware while I'm in there as well. I haven't done any real motor work before. Can I get the head torque sequence and #'s as well as intake sequence and #'s? Any tips or advice would be helpfull too. I'm also switching to roller rockers. Bigbad1/2ton 05-04-2008, 08:10 PM I dont have a picture but it would be in any repair manual. Also put thread sealer on the studs going into the block or they will leak. Also buy a good head gasket like fel pro odin544 05-04-2008, 08:13 PM newbies:shaking: :flipoff2: http://boxwrench.net/specs/chevy_sb.htm Wilson 05-04-2008, 10:08 PM newbies:shaking: :flipoff2: http://boxwrench.net/specs/chevy_sb.htm Found that link and used it, very helpful. Check on the sealer and fel pro gaskets | |