will a 88 engine bolt up to a 82 sj410 tranny and motor mounts?????
l8r

No!

Originally posted by mud-magnet
will a 88 engine bolt up to a 82 sj410 tranny and motor mounts?????
l8r

Why would you want too??????

:flipoff2: :flipoff2: :flipoff2: Honourable Newbie is still at it:flipoff2: :flipoff2: :flipoff2:

thats for my brothers POS, its a 82 sj410, and he blew the engine, so i was just woundering if the spare 88 engine i got would fit in it..........
so what dosn't fit??? the bolt pattern on the tranny, or the motor mounts???
thanks....
:flipoff2: :flipoff2: :D

Why don't you put a 1.3 complete with 5 speed tranny?

ok MR. Rock-God........... i could but would i be able to use the stock 82 tranny mount??? what about the motor mounts??????
:flipoff2:

I know a guy who has put a 1300 and the Sammy 5 speed in his SJ. So I know it can be done, just not quite sure how he did it. I will try to get some more details for you. In the time being you could grab a tape measure.:D

and remember not to ask me for any important measurements:rasta: :D

Originally posted by UZI 9mm
and remember not to ask me for any important measurements:rasta: :D


don't worry about that #2...............:flipoff2:

3.25"..............bhahaha:D :D :D

You will need a sammy tranny and the output yoke.

Match d-shafts at one of the 2 yokes, just use the correct clips for the bearing cup (sj uses C clip inside yoke, sammy uses spring clip outside yoke.

I believe the tranny mount is different, I believe if you look at a sam frame (at least on an 85) you can see where the sj tranny mount used to go and where an extension is welded above for the 1300.

The tunnel on an sj-410 is too small to fit the 1300 tranny as well. Body lift(ugh) or sawzall.

I know the motor mounts differ, my uncle swapped his by cutting a set of a sam, bolt them to the motor, drop in and weld away.

Ken

Same standard procedure, cut - weld, cut - weld, hehe :D

thanks ken, that what i wanted to know....... took 9 posts to get it.......sad, so sad.........:flipoff2:
ayways that for the help ken......
-Mike

:flipoff2: :flipoff2: :flipoff2: Welccome to POR , honorable Newbie:flipoff2: :flipoff2: :flipoff2:

Ya want to come over and install it too??????????????

:rolleyes:

Originally posted by mudlite
:flipoff2: :flipoff2: :flipoff2: Welccome to POR , honorable Newbie:flipoff2: :flipoff2: :flipoff2:

Ya want to come over and install it too??????????????

:rolleyes:


that would be great john........ thanks alot........... save me the trouble...........:D :flipoff2: :D