Looking for someone in Phoenix area to make D60 Truss

[ChicagoDII]

I need to get a truss for my front 60 and rear Sterling 10.5. Both of them need to be very low profile and tight against the housing. Something like 3/8" flat plate bent to fit around the diff and plasma cut at the ends to fit on the axle tube. Then I need the front welded to the diff housing. So if you've got a break press, and are experienced with welding to nodular iron, PM me if you want to make some cash.

[ElLizard]

Is desert fab out of the question?:flipoff2::laughing::p

[ChicagoDII]

Is desert fab out of the question?:flipoff2::laughing::p

Desertfab is the reason I am broke and am trying to find someone on here who has the tools and wants some extra cash. :flipoff2:

[mongosd2]

if you had a sack, you'd call'm and see if they are interested in making right from the last swap:flipoff2:

give Aaron a call, he may know someone...

[el ranger loco]

LostOffroad. PM him for find him
here VVV

[Symon623]

Depending on time frame, I could do it. Or check with Complete Offroad on the west side.

[SHNIPE]

I can vouch for sy. His welds will hold :D

[lancetkenyon]

I can vouch for sy. His welds will hold :D

And look nice too.......