1985 Toyota 4Runner also comes with 16ft car trailer.

Engine

87 sb 350 roller block

- Bored .030 over


- Factory Forged rods and crank


- Roller rockers


- RPM aluminum heads


- aluminum performer intake


- block hugger headers


- Holley 650 cfm truck avenger


- Pertronix flame thrower billet distributer


- FlowKooler water pump


- 100amp 1 wire GM Alt


- Toyota power steering pump


- Dual Flowmaster custom exhaust


- Dual electric fans


- 22x19 Summit aluminum radiator


Transmission

TH 350

- shift kit


- corvette 2500 stall convertor


- Advanced Adapters Tcase adapter


- Toyota Tcase


Suspension

- 4" Skyjackers Waggy springs front


- 56" Chevy rear springs


- 2" body lift


- F350 Front Shock mounts


- Sky Manufacturing rear shock hoop


- Sky Manufacturing Boomerang front shackels


- Allpro High steer


- IFS steering box


- Custom extened long travel front driveline


- Custom rear driveline


- Warn Hubs


- R&D Engineering High strength birfs


- Spooled Rear


- 4.10 gears front and rear


- Chromolly high strength 30 spline rear axles


- Front Backing Plate Eliminator


- Front Axle Truss


Exterior

- AllPro Front winch bumper


- AllPro rear bumper


- 36" Super Swampers


Interior

- Triple Gages


- Simpson 5 point harnesses


- B&M ratchet shifter


$6500.00 complete package deal. This set up has around 50 hrs on it since built. Located in Western Washington I can email pics to anyone that would like to see it. I will try and post a few in the next day or two.


Email - olympiaexteriors@yahoo.com

Home - 360-584-9500

Cell - 253-330-3734

http://i28.tinypic.com/sxbpds.jpg

http://i30.tinypic.com/1268jef.jpg

http://i28.tinypic.com/2hgvio2.jpg

also want to add that I took it to a dyno shop to get it tuned and it produces 148 hp out the rear wheels, that is with 36" swampers and stock gears.

Not being a dick but with the above mentioned about the engine mods i have a hard time beleaving it only made 148 HP at the wheels. It should be way higher then that.

Not being a dick but with the above mentioned about the engine mods i have a hard time beleaving it only made 148 HP at the wheels. It should be way higher then that.

X2 on that. I would take it to a different shop.

th hp would be probably 20-30% more if I were to have smaller not as knobby of tires on it when it was on the dyno. The rollers against the swampers make drag and the dyno reads it as that, at least that is what I was told. also it only has 4.10 gears in it. with the gears and tires the power is reduced at the wheels and on the dyno it can not read the hp accurately. after he did the math he estimated the engine right at 300 hp. the 148 hp read out was also @3800rpm as he stated much more then that and the tires could suffer damage from the heat and the rollers causing the lugs to rip off. I was told also that if I was to put street tires on it and then test it it would be closer to 200hp out the rear.

pics to muglug31@yahoo.com please. How old are those tires?

the tires were brand new when built. maybe seen 50 miles on pavement always trailered. The tires only show wear from the trails. what kind of pics are u looking for other then what is already shown ??

How about a shot of the dash and maybe one of the rest of the interior. Also is the front axle open? Thanks