I need a yoke for my D60 and I would like to have the part # to make it easier to get the right one. It is for a fine spline 60 pinion. I want the one that uses u-bolts, for a 1310 u-joint. the one I have is too thrashed to tell what it was. Also does anyone know if there is one that alows for a grater working angle?
Anyone know it? Gearman? High Angle?

Thanks

I have a 1410 one in stock has the best working angle available- 79.00 and u bolt style- i do not stock the 1310 one - JEss

that will be listed in the dana expert site in the driveshaft section under unwelded assemblys I think.
it is in the ujoint catalogue as well
but I am not 100% it is ubolt...

Originally posted by mj
that will be listed in the dana expert site in the driveshaft section under unwelded assemblys I think.
it is in the ujoint catalogue as well
but I am not 100% it is ubolt...

whats the sites addess? I havent heard of it?

Dana part # 2-4-3801x. 1 1/4 - 29 spline 1310 U-bolt yoke $34.02

**I agree with Jess at least 1350, but if 1410 has better angle go that route**

in my opinion 1310 does not belong on a dana 60 -Jess:)

so does a 1410 break before the 60s weak link?
I would rather drop a shaft then break an axle or carrier.
I only have a 1330 dif u joint and the tiny 1310 CV.
the CV pukes way to soon

For all the Spicer pdf catologues, check the pdf section of my site