I am installing a Dana 300 to AX15 and the Dana 300 shifter assembly hit the support bar on the body.

I am using the AA clocking ring and mounting it horizontal.

To those who have mounted this did you have to cut your body to make it fit without a body lift? Any pics of what you cut would be awesome. Feel kinda off about hacking into this support bar.

Thanks!!

If your seats are still mounted too the floor then i prob would not cut to far in to the support. But if your seat are mounted to a cage then hack away. I cut my whole tranny hump right out and rebuit it to fit the clocked 300.