I know this may have been talked about somewhere, but search left me with nothing. I hear people talking about putting the 5on5.5 outers on the Waggy D44, but can it done the other way around?

Can I put the 6 lug outers from a Waggy D44 on an EB D44?

I dont see why I couldnt, I just wanted to make sure...

if you have the Gm or Waggy knuckles then don't see why not..

yea, use the gm or waggy knuckles... im using a eb axle with chevy flat tops, chevy outers, and eb inners.

if it has the 6bolt spindle you can use the stock eb knuckle. and a large bearing gm spindle/hub rotor

if it has 297 joints use the gm outer shaft if it has a 260 shaft remove .070 from the inner hub gear and use the stock eb outer shaft.

i have done the latter on a friends eb but used 8 lug hub/rotors to match the 60 he put in the rear until he could find a front 60.