SCORPION
07-23-2002, 12:31 PM
I searched......
I want to swap out the front (strap and bolt) out-put yoke on my 231 for a u-bolt stile yoke. My question is, can I use the same yoke that works on my dana 30 an 44 pinion? I would drill the original one out, but I dont think there's enough clearance.
thanks:confused:
Travis Waldher
07-23-2002, 04:00 PM
Not sure... guessing not.
What you could do. Go to a full size truck running a NP/NV231HD. It will probably have U-bolts vs. the straps and should bolt right on.
Or, call Jess at HighAngle.
SCORPION
07-23-2002, 06:37 PM
what trucks have the nv231?
SCORPION
07-24-2002, 08:15 AM
Any one know the spline count on that font t-case output shaft? I know the pinion on a 30's is 26 spline and 60's have a 29 spline pinion shaft. would a 60 yoke work?
bigdude
07-24-2002, 11:43 AM
Originally posted by SCORPION
Any one know the spline count on that font t-case output shaft? I know the pinion on a 30's is 26 spline and 60's have a 29 spline pinion shaft. would a 60 yoke work?
231 front output is 27 splines, same as D300. (best of my knowledge)
Imkunfused
07-24-2002, 11:58 AM
Originally posted by bigdude
231 front output is 27 splines, same as D300. (best of my knowledge)
ding ding ding.. same as the rear output on a 231
bigdude
07-24-2002, 12:05 PM
Originally posted by ImKuNfusED
same as the rear output on a 231
Naw, my rears 32 :D
hybrid
07-26-2002, 06:38 PM
Why change the one at the t-case? Will you still be able to get to them that way without dropping the skid plate?
Imkunfused
07-26-2002, 10:28 PM
Originally posted by bigdude
Naw, my rears 32 :D
Dude.. i dont wanna know what you can stick in your rear....:flipoff2: :flipoff2:
I guess i should of said stock output..
Recurve
07-27-2002, 08:57 AM
If you ever switch to a CV style front shaft then you'll need to switch it back.