|
Rookie 10-13-2001, 11:33 AM I'm looking for reverse cut dana 60s, front and rear. I'm wanting around 67-inches, driver's side front. Is there any donor vehicles out there that would be close to what I'm looking for? TIA Rookie [ 10-13-2001: Message edited by: Rookie ] The Rockslut 10-13-2001, 11:37 AM Reverse cut front is on going to come in a Ford fronts They are all driver side diff Rookie 10-13-2001, 11:41 AM So, how close would it be in the width? Also, would I be able to find a reverse cut Dana 60 rear from a Ford? I'm gonna try to DIY on my axles, wish me luck... Rookie [ 10-13-2001: Message edited by: Rookie ] The Rockslut 10-13-2001, 11:49 AM To do reverse cut front and rear you need 2 Front Ford reverse cut axles. Or you can get a Tera or Dynatrac setup. They fronts are wider than 67" I do believe but they are close. To do a rear you have to retube the short side and get some brakes. PITA if you ask me. Reverse cut is sweet but a lot of $$$$ Rookie 10-13-2001, 11:53 AM Thanks - I've got a friend that can do whatever I need as long as I explain it to him (he's a sprint car guy). I'm trying to figure out if it will save me money if I have him do it versus buying them already built... Rookie The Rockslut 10-13-2001, 12:53 PM If he can do some of the work it will probably save you some $$$$ Just keep asking questions and do it once isntead of 4-5 times Rokrunner 10-14-2001, 08:48 AM BTW my ford dana 60 front is 69" WMS to WMS Hope it helps | |