so is there a writeup on were someone put the 8v fuel injection on there 1.3?

it looks simple enough but...
do i need to take the whole intake man off or just the throttle body?(looks like all i need is the throttle body?)
and for the wiring harness just take the wiring loom that connects to the throttle body? and take the computer out too?

i am going bare bones on this so i don't need stupid stuff like speedo or the gauges.
if anyone can point me in the right direction that would be great.

What are you taking the FI off of? A zuk or a swift? If its a swift, I know it needs the intake. I have this on mine so can answer Q's on it. The zuk FI, I believe needs the throttle body intake, but am not sure.

These are supposed to have the VSS attached to the speedo, but it will work just fine without it. will just not have that signal so fuel milage may suffer as it will tend to run a little rich. Not sure exactly why, but two I have done without the VSS seem to run rich.

its off a tracker.

manifolds are differant your gonna need various sensors and the distributor

ok well i have the manifold. and i think there is a distributor around somewhere?

I am pretty sure the distributor is going to depend on year of the donor vehicle. My tracker is a 90 and the dizzy is the same as in a carb sami...so it is possible you can use the distributor that you have.

Kent you can look at mine any time, that is what I have on mine!

so know one else has done this swap??? really?