|
MikeW 07-25-2002, 07:50 PM Ok I brough superlift add a leaves, the long ones which are a single leaf for each side. and some bolts. How do I put these on, and how hard is it? And any advice for putting front coil springs on? Its a 1996 Ford Bronco. I tried the seach nothing came up ecrist 07-25-2002, 08:39 PM I personally would start by RTFM (Reading the Fucking Manual).... Thats how I did mine.:flipoff2: MikeW 07-25-2002, 08:57 PM :flipoff2: Ecrist, Im trying to save some bucks here, so Im just asking for advice how to do this ok? SMART ASS 07-25-2002, 11:41 PM :rolleyes: its gunna be a long night... to be honest, if their was anything cake to do / work on my rig that would be the ezest thing 2 do.... All you have to do it, jack up the frame Place solid jack stands under the frame (each side) Remove both tires Place hydro floor jack under pass side of axle Remove pass side u-bolts lower the axle, enough so that you can unbolt the main leaf center bolt for the spring pack... unbolt the center pin on the spring pack incert the aal where ever you want within the pack... Use your new bolts (longer) to bolt the center pin for the spring pack back together into leaf sprung shape... Raise the axle back into place Re-bolt with the u-bolts your spring to the perch to the axle... do the same for the drivers side... RE TORQUE EVERYTHING !!!! SMART ASS 07-25-2002, 11:42 PM Oh yeah, and get some air tools ;) they make things like this cake! MikeW 07-26-2002, 03:45 PM Thanks | |