OK, the fuel cell comes with a size 10 male fitting (other fittings are 8). The fuel line is 1/2 inch. I only need it to be 1/4 inch.

So, were can I find a reducer (a = 1, not 8 like I have found) to handle this problem??

Thanks,

SPEED SHOPS OR SUMMIT RACING....YOU CAN GET A FITTING THAT WILLL CHANGE -AN- TO NIPPLES

YEAH NIPPLES:D

Just use JIC fittings from your local Hydraulic shop and save a ton of $$

I got my reducer from Summit for like $9 and change. Took the 10an down to 3/8. They also have the reducer to take the 10an to 1/4 as well. Do a search on their website and you will see em.

-10 AN to 3/8 inch part # is AER-FCM2523 Not sure what the 1/4 inch adapter part is. :D

Chris

Thanks guys.

The guy at Summit (on the phone) had about $300 in fittings to do what one or two would do. He just didn't understand.

Originally posted by Scout Dude
Along the same lines, my fuel cell is arriving today and I need to buy fittings at lunch (Jimmy, if you read this--got it figured out)

I have a Chevy 305 currently but will step up to a 350 or whatever...I use an Edelbrock 600 carb.

So, can I block off the #10 and use the #8? I figured that this should be big enough. Anyone have any ideas?

#6 and 3/8" lines will support up to 400hp worth of gas flow.

Here is my fuel fliter in 3/8"