hey yall i am wondering the weight of a ttb 35 please

350-400lbs...with arms..

350-400lbs...with arms..

Or as some would say $200 per ton

I honestly don't know. How much does "ghey" weigh, in pounds :confused:

thank guy i got my spring for my coil overs ordered i asked because need to know unsprung weight

i estimate 200 pounds unsprung weight on that turd......please tell me yer building for desert running....

Or as some would say $200 per ton

:laughing:

I honestly don't know. How much does "ghey" weigh, in pounds :confused:

I unno...how much do you weigh again?













:flipoff2:

They're between 200-250lbs complete (probably a little under that of a D44).

The unsprung weight will effectively be somewhat less though on a TTB (due to how it pivots) The amount will be different for both driver & pass sides as well.

Fortunately it's not really all that critical. Most important is that the springs are sized to give you the proper height so the camber is correct.

no a rock crawler already have a 44 cut down to eb length and will be remove that thing that resembles what my dog makes in the yard. I'm going 16in foa coil overs extended radius arms with johnny joints. tell me any thing else i need

They're between 200-250lbs complete (probably a little under that of a D44).

Yeah, I'd say closer to 250. Just tossed one of those boat anchors on the trailer before heading to the scrapper.

Have you considered air shocks? We just built a B2 with a full-width D44 and extended RAs, and 2" SAWs work pretty darned good.

i did but i can see the sand dunes from my house and the coil over ride so nice out there