I am sure that this has been discussed before I found this board, but is there a way or has anyone tried to make Heim Jointed Front Radius Arms? I don't have a clue if it would work, so I figured I'd ask you guys. I am sure at least someone has tried it.

:flipoff2:


Brad

Check the search button. It has been discussed several times. In short, no it doesn't work......think radius and there is your answer.

Way

not completely true adam. I run a hiem like front radius arm (jonny joints) but they are only at the frame mount and I have a very different frame mount from stock. It does work and works well if you only put them on the frame mount and redesign it to flex.

-ben

I'm sure what Adam is referring to and what i took the question to ask, is about spherical bearings in the axle end of the arm. The answer is then no it doesn't work at all. I tried this back in the summer of 97 and several people have also discovered on their own that it doesn't work.