Curious as to if there is a yoke avail. to convert Dana 44/60s to Toyota style yoke flanges. I've been searching, but haven't found em yet

Yes, Jess at High Angle Driveline (http://www.highangledriveline.com) made a Dana 44 pinion flange that adapts the aforementioned axle to a Toyota driveshaft.


http://tellico.off-road.com/wwwthreads_uploads/842589-

Can't seem to post this picture. Click here (http://tellico.off-road.com/wwwthreads_uploads/842589-toyota_dana44.jpg) to see a picture.

You can also, just have a driveline built that has toyota cv joint with chevy longer travel slip joint on the other end.